Quarter/Fixed Preparation & Installation

Quarter Fixed Prep Install Tutorial

Clean surrounding door panel and rubber seals. Scrub glass and squeegee clean. Remove and discard clear liner while soaking template. Place template on window. Squeegee slip from template. Wick film edges using lint-free towel. 

Back Glass Installation

Backglass Install Tutorial

Mount template to outside of back glass. Remove and discard clear liner while soaking the entire template. Fold template and carry into car. Unfold template and place on glass. Set/Squeegee  “+” pattern. Squeegee from center out to edge in each section. Wick film edges dry. Clean and inspect. 

Back Glass Preparation

Backglass Preparation Tutorial

Remove headrests and slide front seats forward. Clean rear deck and surrounding B pillars. Mist window and scrub using white scrub pad. Squeegee from Left to Right. Soak window with DigiSlip. 

Front Roll-Up Installation

Front Roll Up Tint Installation Tutorial

Mount template to outside of glass.Remove and discard clear liner while soaking the window tint template. Place temple and set/squeegee top edge approximately 4 inches. Roll the window upPick up template and spray slip in a downward direction. Tuck template into bottom of window. Set/squeegee vertically down the middle of window.Squeegee remaining slip from template.  Wick edges of film using lint-free towel. Clean and inspect. 

Front Roll-Up Preparation

Front Roll Up Install Preparation Tutorial

Mist and clean outside of window.Mist and scrub inside of window.Squeegee window clean from front to rear of window. Re-mist window and roll down 2-3 inches.Scrub and squeegee clean.Clean door panelSoak window and flush sides. 

Door Handles & Door Edge Guards Preparation & Installation

Door Handles and Door Edge Guards Prep and Install

DOOR HANDLEPrep and clean painted surface.Place template in center of door handle.Set/Squeegee a “+” pattern.Remove remaining solution.Wick film edges. Heat seal film edges. DOOR EDGEPrep and clean painted surface.Place template with 1/4 inch notch on the outside of the door. Using other hand as a guide set/Squeegee in place. Firmly pull door open. Roll edge guard around door edge toward inside of door. Heat film edges. 

Mirror Preparation & Installation

Mirror Prep and Install Tutorial

Prep paint surface with clay sponge.Spray painted surface and template with demoter.Place template on mirror back aligning the area closest to the vehicle first. Set/Squeegee 1-2 inches on area closest the vehicle.Stretch template around mirror and set/squeegee down the middle. Set/Squeegee top and bottom. Wick film edges. Heat seal film edges.

Fender Preparation & Installation

Fender Prep and Install Tutorial

Prep painted surface with clay sponge.Separate the liner from the paint protection film template and discard the liner.Set/Squeegee leading edge of template. Set/Squeegee back toward rear of vehicle.Wick film edges.Heat seal film edges.

Hood Installation

Hood Installation Tutorial

Spray painted surface with demoter.Place template liner out upside down at top of the hood.Separate the liner from the paint protection film template and discard the liner. Place template adhesive side down in the center of the leading edge of hood. Set/Squeegee center of the hood. Stretch to first anchor point and squeegee 3-4 inches on the leading edge of the hood. Remove remaining demoter solution by squeegeeing back toward windshield.Wick film edges. Heat seal film edges.