Prep painted surface.Place template in center aligning the “V” notch with trunk/hatch opening. Set/Squeegee center.Stretch to anchor point on left or right. Remove any remaining demoter. Wick film edges. Heat seal film edges.
DOOR HANDLEPrep and clean painted surface.Place template in center of door handle.Set/Squeegee a “+” pattern.Remove remaining solution.Wick film edges. Heat seal film edges. DOOR EDGEPrep and clean painted surface.Place template with 1/4 inch notch on the outside of the door. Using other hand as a guide set/Squeegee in place. Firmly pull door open. Roll edge guard around door edge toward inside of door. Heat film edges.
Prep paint surface with clay sponge.Spray painted surface and template with demoter.Place template on mirror back aligning the area closest to the vehicle first. Set/Squeegee 1-2 inches on area closest the vehicle.Stretch template around mirror and set/squeegee down the middle. Set/Squeegee top and bottom. Wick film edges. Heat seal film edges.
Prep painted surface with clay sponge.Separate the liner from the paint protection film template and discard the liner.Set/Squeegee leading edge of template. Set/Squeegee back toward rear of vehicle.Wick film edges.Heat seal film edges.
Spray painted surface with demoter.Place template liner out upside down at top of the hood.Separate the liner from the paint protection film template and discard the liner. Place template adhesive side down in the center of the leading edge of hood. Set/Squeegee center of the hood. Stretch to first anchor point and squeegee 3-4 inches on the leading edge of the hood. Remove remaining demoter solution by squeegeeing back toward windshield.Wick film edges. Heat seal film edges.
Wash entire car as you normally would and get any paint correction completed. Use clay sponge to remove surface contaminates.Inspect for any missed or rough spots and repeat if necessary.